Parking heater extension chamber-Air heater

Manufacturers, various specifications, convenient installation
This product is specifically for diesel car parking heater, design and development of the combustion chamber, not easy to produce carbon accumulation, combustion more fully.

Want wood to warm you up on a cold day? How do you do these steps
Whether the interior of the wood warm is clean is the main reason to determine the good use of the wood warm, which involves the sorting of the wood warm to see the internal structure. At present, the basic structure of the mainstream wood heating on the market is much the same, mainly by the shell, motor assembly, circuit board, ignition needle, combustion chamber, aluminum body, atomizing net, temperature sensor and heating needle.
During normal inspection, it is recommended that you take out the wood warm from the shell, remove the circuit board and dismantle a few screws of the aluminum body shell to successfully decompose the whole wood warm, after decomposition, you can see the motor assembly, combustion chamber, ignition needle and aluminum body inside. Wood that has been used over the winter and stored away can accumulate a lot of carbon. And if your use condition is not good, a lot of debris is also easy to be inhaled into the wood warm inside the wood warm atomizing net and other parts of the blockage, so it is quite necessary to open clean.
And the internal carbon accumulation is too much, will also cause the internal combustion of wood warming has been in the combustion of insufficient, over time, the effect of wood warming will be worse, and finally can not be used. Therefore, it is recommended that even if your wood warm can be used normally, it is also best to decompose the whole wood warm before restarting, remove the internal carbon and sludge, so that the wood warm can work refreshing.